Forums >> Revit Building >> Technical Support >> Stair railing at extension in Revit 2012

erickson1026

active

Joined: Thu, Apr 29, 2010
34 Posts
No Rating

Hello,

I have searched around and can't quite find a resolution to the attached pdf.  I have built a custom baluster for the extensions, but the diagonal rail and top extension don't meet.  Any tips would be most appreciated.

Revit 2012

Thanks!

This user is offline

erickson1026

active

Joined: Thu, Apr 29, 2010
34 Posts
No Rating

Nevermind I got it.  I had the rail path too long...brought to the start of the first riser and it worked out.

This user is offline

alabaster2513

active

Joined: Tue, Jan 16, 2007
1009 Posts

good

This user is offline

View Website

CDWdavid

active

Joined: Mon, Aug 4, 2008
153 Posts

Do you really want to place the railing post at the edge of the nosing?

The way I did was to create two extensions, one for top one for bottom.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

Actually, you don't have to do that.  If you break your railing sketch line at the point where the railing will break from soped to flat, and assign the flat area of the sketch to flat, you can move that post.  The only problem is the railing change of angle will be a miter and not a gentle curve.

This user is offline

ERROR IN STRUCTURE EXTENSION

0

Railing Extension Problem

1

Revit Architecture 2013 - Known Issues

0

Creating Families

2

Copy/ Monitor Generic Models

1