Forums >> Revit Building >> Technical Support >> Can't creat multistory stair

rabbitcookies

active

Joined: Sun, Feb 7, 2010
5 Posts
No Rating

I want to create a ordinary stair from level 2 to level 4, both levels are 3000mm at height.

I create a stair from level 2 to leve 3 and it is fine. After finishing it, I click the stair and try to change Multistory top level to level4, but I get the warning as:

Multistory stair/ramp could not reach its top level w/ integal number of flights, maximum number of flights below the top level is created.

I don't understand the warning and is anything I did not right to create multistory?

Thanks in advance

This user is offline

mbsteve

active

Joined: Fri, Sep 22, 2006
759 Posts

make one level change copy to next level

This user is offline

emgeeo

active

Joined: Wed, Mar 12, 2008
322 Posts

welcome to the club!

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Don't just copy the stair.  If the stair has no more than two runs, then you should be able to just set it as multi-level. 

Did you set this stair to go from level to level?

This user is offline

Stair Riser/Tread Number in Multistory Stairs

7

Handrail Supports on Multistory Stairs

3

Stairs - Multistory Monolithic Rev 2014

2

how to creat a doom roof

5

multistory stairs skiping levels

3