1773 Downloads

No Rating

Revit vertical braces do not show correctly cut @ 4'-0" on architectural plans.  This bracing family solves this problem.  Here the instructions:

1. Load the vertical bracing to the project
2. Go to modelling, structural, brace and choose vertical bracing
3. Pick start level, set 0'-0" (should always be 0'-0").  Pick end level (should always be the same as start level, set 0'-0" (should always be 0'-0")
4. Draw horizontal length of brace on plan
5. Go to element properties, set "Height" parameter (vertical distance measured from brace start floor level to top end of brace), set "Base Offset" parameter (location of start end of brace

Product Version: Revit Architecture 2008

Uploaded By: ktam
Uploaded On: Thu, Feb 14, 2008