 |
VISIT HILLPHOENIX.COM |
No Rating |
Product Version: Revit Architecture 2015
190 Downloads
|
|
 |
|
No Rating |
Product Version: Revit Architecture 2015
4438 Downloads
|
|
|
 |
Series B6000, B6001 2-Piece, Standard Port, Bronze Ball Valves are used in commercial and industrial applications for a full range of liquids and gases. It features a blowout proof pressure retaining stem. The B6000, B6001's standard port orifice ensures minimal pressure drop, while Durafill and Uniseal seats and chrome plated brass ball provide lasting service. Model B6000 has threaded NPT end connections and Model B6001 has solder end connections. Pressure Rating: For 1/4 to 3 in. - 600psi WOG (non-shock); 150psi WSP; For 4 in. - 400psi WOG (non-shock); 125psi WSP. |
No Rating |
Product Version: Revit MEP 2010
282 Downloads
|
|
|
 |
Recuperador de calor generico para uso MEP |
No Rating |
Product Version: Unknown
136 Downloads
|
|
|
 |
Series ISCA-122 Industry Standard single vertical adjustable water closet carrier with epoxy coated cast iron fitting, 4 in. (102mm) no hub waste and 2 in. (51mm) no hub vent connections, epoxy coated ductile iron compression seal faceplate assembly, epoxy coated ductile iron foot supports and rod support assembly adjustable for standard and wheelchair height, ductile iron rear anchor support, adjustable ABS nipple with integral test cap and neoprene bowl gasket, stainless steel support rods and hardware, and chrome plated cap nuts. Carrier complies with requirements of ASME A112.6.1M up to a 1000 lb. (454 kg.) static load. The closet carrier legs are embossed with incremental measurements markings, allowing contractors to easily adjust the height of the carrier to the most commonly used fixture requirements. |
No Rating |
Product Version: Revit MEP 2014
34 Downloads
|
|
|
 |
|
No Rating |
Product Version: Unknown
680 Downloads
|
|
|
 |
LISETTA ARMCHAIR BY ELENA SALMISTRARO Bottega Intreccio |
No Rating |
Product Version: Revit Architecture 2020
451 Downloads
|
|
|
 |
MIFAB® Series F1100-C-T(*)-3 (* specify strainer diameter) lacquered cast iron floor drain with anchor flange, cast iron membrane clamp with primary and secondary weepholes for waterproofing membrane, and heavy duty, solid, gas tight, spanner wrench, vandal proof, stainless steel cover for secured access. (For non-membrane floors, use MIFAB F1100-T Series.) |
No Rating |
Product Version: Unknown
34 Downloads
|
|
|
 |
MIFAB Series MI-G-L-SDH ____ sanitary acid resistant, powder epoxy coated inside and outside fabricated 10 gauge steel hydro mechanical grease interceptor with flow rating of ____ (indicate) and grease holding capacity of ____ (indicate). Unit shall include: removable baffle assembly and cross bar, internal deep seal trap covered by lid, sewer gas stopper, securing bolt(s), external vented flow control fitting, internal air relief by pass, feet underneath interceptor to elevate it ½” off the ground, internal steel cone, flexible drawoff
hose and cap, hose clamp, line shut off valve and steel acid resistant, powder epoxy coated, non skid, rectangular gasketed lid(s). |
No Rating |
Product Version: Unknown
141 Downloads
|
|
|
 |
Mortal Kombat Logo recreate within Revit. Use for floor tiling. |
No Rating |
Product Version: Revit Architecture 2017
238 Downloads
|
|
|
 |
|
No Rating |
Product Version: Revit Architecture 2018
740 Downloads
|
|
|
 |
This is a standard design for R.R.Dry Stone masonary Retaining wall to support the hill roads. As normally the maximum length of hill roads are supported by these dry walls which do not use any mortar for masonary, to control the cost. Filling behind the wall has also modelled for explaining purpose, which may be removed. |
No Rating |
Product Version: Revit Architecture 2018
270 Downloads
|
|
|
 |
CABLE TRAY 梯垂直外彎,CABLE TRAY OUTSIDE BENDING |
No Rating |
Product Version: Unknown
41 Downloads
|
|
|
 |
Rectangle Duct Horizontal Connection to round duct |
No Rating |
Product Version: Unknown
2936 Downloads
|
|
|
 |
Treadmill |
No Rating |
Product Version: Revit Building 5.1
14887 Downloads
|
|
|
 |
Ceiling Fan |
No Rating |
Product Version: Unknown
2913 Downloads
|
|
|
 |
Love Seat |
No Rating |
Product Version: Unknown
2023 Downloads
|
|
|
 |
Dining Room Table |
No Rating |
Product Version: Unknown
3211 Downloads
|
|
|
 |
Street Light with Wing Shaped Reflector |
No Rating |
Product Version: Unknown
3693 Downloads
|
|
|
 |
Same as orginal but with parameters fixed (now works for different sizes). |
No Rating |
Product Version: Unknown
3601 Downloads
|
|
|
| |
Fluted Pilaster w/ adjustable Height, Width, and Wall Projection. If you're family savvy you can add parameters for top and base adjustments. Two material controls. |
No Rating |
Product Version: Unknown
1760 Downloads
|
|
|
| |
|
No Rating |
Product Version: Unknown
262 Downloads
|
|
|
| |
|
No Rating |
Product Version: Revit Architecture 2009
1355 Downloads
|
|
|
| |
|
No Rating |
Product Version: Revit Architecture 2009
660 Downloads
|
|
|
| |
This is a generic 32 track Mixing console with ballparked sizing |
No Rating |
Product Version: Revit Architecture 2009
1891 Downloads
|
|
|
| |
SemiCircle Desk Counter and matching countertop |
No Rating |
Product Version: Revit Architecture 2009
2449 Downloads
|
|
|
 |
The playstation three slim, modeled to exact scale |
No Rating |
Product Version: Revit Architecture 2010
6075 Downloads
|
|
|
 |
|
No Rating |
Product Version: Revit MEP 2010
392 Downloads
|
|
|
 |
|
No Rating |
Product Version: Revit Architecture 2009
581 Downloads
|
|
|
 |
This is the ‘one’ leaf that some people asked for. It is nested in the leaf 1 family that I upload not long ago. One can create few types for the leaf with deferent angles and material and insert back to the Leaf 1 family.
nirim |
No Rating |
Product Version: Unknown
3567 Downloads
|
|
|
Search