Parametric (I think) Embedded Strip Light with Casing. 

Product Version: Unknown

10783 Downloads

Ceiling Fan With Light, 

Adjuestable Width & Color of Fan

No Rating

Product Version: Revit Architecture 2013

9400 Downloads

Eaton’s enclosed circuit breakers offer all the advantages and accessories of a circuit breaker packaged in an enclosure for nearly any application requiring a means of disconnect. Ideal for a variety of locations including general purpose, rainproof surface mounting, water and dustproof, dustproof surface mounting, and hazardous locations.

Product Version: Unknown

4289 Downloads

OVER-ALL

Art. S.1910W 9 MODULES LED 3000K  Max. 700mA 1755lm CRI 90 MacAdam step 3Rated luminaire luminous flux: 1569lmRated input power: 20.2WLuminaire efficacy: 78lm/WRequires remote ON-OFF power supply or Dimmable power supply CE - ENEC 03LUMINAIRE TYPESurface mounted up-light fitting . IP rating IP 65 IP67MATERIAL CHARACTERISTICSDie cast EN AB-47100 aluminium (low copper content) housing with high corrosion resistance. Stone wash surface treatment prior to painting process. A4 grade Stainless Steel screws with 2,5-3% molybdenum content which increases the resistance against corrosion. Mechanical resistance IK 08 Maximum load capacity --LIGHTING PERFORMANCEClear polycarbonate lenses. Toughened glass 5mm Micro Over-all, 6mm Mini Over-all, 8mm Over-all. Lamp  fixed position. LOR -- LOW SURFACE TEMPERATURESurface temperature of glass -- (Ta 25°C)INSTALLATION AND MAINTENANCEA4 stainless steel fixing clips. Over-all is supplied with a nylon insulating fixing base and 2 special keys (necessary to remove the luminaire). Allowing direct fixation to the solid ground.WIRINGSupply 5m cable section type H07RNF sealed with B component epoxy resin, wired internally protected by silicon sheaths. Isolation: CLASS III . Available colours: Aluminium grey (cod.14). Weight: 2.13 Kg Glow Wire test: --LED circuit included.OVER-ALL REGISTERED DESIGNThis luminaire contains built-in LED modules. In case of damage or malfunction please contact the manufacturer to receive additional instructions on how to replace and relative spare parts to order. The LED modules cannot be handled in the luminaire by the end user.LED modules are engineered accordingly to the existing regulations of Lumen Maintenance (LM80) and Technical Memorandum (TM21), where uniformity and quality of the light is 70,000 hours referred to L80 B10 Ta 25 ° C (50,000 hours referable to L80 B10 Ta 40°C). Lifespan of the luminaire > 50,000 hours at 40°C. Performance Ambient temperature Tq 25°C. Operating ambient temperature range is from -20°C to +50°C. Storage temperature range from -20°C to +60°C.

No Rating

Product Version: Revit Architecture 2018

498 Downloads

Basic floor Lamp w/ working light

No Rating

Product Version: Unknown

8545 Downloads

The Radial Slot Diffuser (RSD) produces a high induction radial swirl pattern which promotes rapid temperature equalization and is suitable for VAV applications where high turndown is present. This product can be installed in standard 24 in. x 24 in. lay-in ceiling grids or surface mounted using a plaster frame.

No Rating

Product Version: Revit MEP 2020

73 Downloads

Hi one and all!

Heres one for today, a nice modern light fitting.

Theres the usual parameters that i put with all my families, Ceiling drop parameter and also 3 main material parameters.

Enjoy and hope it comes in useful

Product Version: Revit MEP 2014

19554 Downloads

This is a helix Wind turbine from HelixWind.com.  This is model S594 according to the spec sheet I modeled it from.  This particular model is meant to mount to vertical planes such as a wall.  Image shows wall mounted Turbine.  Modeled for Sebass.

No Rating

Product Version: Revit Architecture 2008

1760 Downloads

Last one for the lighting. I've had a couple of options chucked at me with regards to different fittings on a job i'm doing so i thought i'd be kind and share....

This is like all my other light fittings, materials are changable and the pendant drop from ceiling is adjustable.

Face based family.

Cheers and enjoy

Product Version: Revit MEP 2014

20862 Downloads

This is the Spectra SP1.  This is based on the CAD file available on www.aal.net.  I don't work for them; I just modeled their light because I needed to use it in Revit.

No Rating

Product Version: Revit Architecture 2008

10565 Downloads

Parking lot light pole for parking lot light fixtures. Parameters for overall pole height and concrete base height.

No Rating

Product Version: Revit Architecture 2008

16860 Downloads

Just a small pendant light with small leafy detail.

No Rating

Product Version: Revit Architecture 2015

3055 Downloads

Parametric sky light roof 

Product Version: Revit Architecture 2012

11961 Downloads

Based on the Possini Euro Design Industrial Cage Light 6"

Product Version: Revit Architecture 2013

10815 Downloads

Base Cabinet - Acid Cabinet - Wall Mounted - Lab

Product Version: Revit Building 5.1

11469 Downloads

heres a red pendent light.

No Rating

Product Version: Unknown

3905 Downloads

light mirror

Product Version: Revit Structure 2013

3878 Downloads

hold up light symbol

No Rating

Product Version: Unknown

811 Downloads

Road Light Revit 2009

Product Version: Revit Building 9

8136 Downloads

Bobrick Wall mounted Toilet Roll Holder

Product Version: Revit Architecture 2011

21965 Downloads

Return Grille with Trim - Ceiling Mounted

Product Version: Revit MEP 2013

4535 Downloads

This is a Light pendant with adjustable pendant drop height from ceiling, modifiable Pendant shade material and Pendant fitting materials

Enjoy

Product Version: Revit MEP 2014

29973 Downloads

Build Traffic and Street Light

No Rating

Product Version: Revit Architecture 2017

9501 Downloads

MIFAB® Series F1100-C-FC( )-1 lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and “FC” (specify diameter) round, reinforced satin finished nickel bronze strainer with surface membrane clamp and vandal resistant, allen key screws. (For non-membrane floors, use MIFAB F1100-FC Series.)

No Rating

Product Version: Unknown

53 Downloads

Hollow metal doors with adjustable swings and single rabbit frames.  Flush, narrow light, half light and full light door types.

No Rating

Product Version: Unknown

1337 Downloads

End table with working light. Materials are already loaded. Changeable if desired. Second upload. First with lighting. Comment and let me know.

Product Version: Revit Architecture 2009

9241 Downloads

Recreation of Hood Classic Pendant Light by Rejuvenation

Revit 2022 File

Product Version: Unknown

554 Downloads

Recreation of Hood Classic Pendant Light by Rejuvenation

Revit 2022 File

No Rating

Product Version: Unknown

294 Downloads

Hey guys!!!....Here is a high bay light I modelled. It is fully parametric. Check it out

Please rate and comment

Product Version: Unknown

12435 Downloads

AVENUE STREET LIGHTING 36led

Art. S.3090N36 MODULES LED 4000K  220-240Vac 12614lm CRI 80 MacAdam step 3Rated luminaire luminous flux: 9976lmRated input power: 107WLuminaire efficacy: 93lm/WElectronic ballast  ON/OFF not dimmable CE - ENEC 03LUMINAIRE TYPEPost top luminaire. IP rating IP 66MATERIAL CHARACTERISTICSExtruded EN AW-6060 aluminium profile, die-cast EN AB-44100 aluminium housing (copper free) with high corrosion resistance. Stone wash surface treatment prior to painting process. A4 grade Stainless Steel screws with 2,5-3% molybdenum content which increases the resistance against corrosion. Pre treated Silicone Gaskets. Painting Process : 3 Step Process1) Surface treatment with BONDERITE. A heavy metal free chemical surface treatment containing ceramic nano particles giving a cohesive, inorganic and highly dense protective coating. 2) PRE POLYMERIZATION a process of introducing an epoxy primer with excellent characteristics to the paint which also offers very high resistance to oxidation due to its Zinc content. 3) POLYMERIZATION a process with the application of polyester powder with high resistance against UV rays and harsh weather conditions. Resistance test protection for Marine applications for 1200h. Mechanical resistance IK 07LIGHTING PERFORMANCEThe circuit is characterized by a series of LEDs specifically oriented to assure excellent light distribution on the street. PARK supplied with electronic circuit with temperature sensors for each LED to optimize the lifetime. The light distribution is in accordance with light pollution regulations. Lamp  fixed position . LOR -- POLE CONNECTIONPole mounted in painted aluminium with Ø 102 mm connection. ON REQUEST ADAPTOR for cylindrical poles Ø 76 mm.WIRINGPROTECTIONS AGAINST DISCHARGES AND HIGH VOLTAGE SPIKES, Controlgear equipped with protections against discharges and high voltage spikes on the mains: 3,5kV differential mode (L-N), 4,0kV common mode (PE).Luminaire hard wired with H05RN-F cable. Fast connector IP67 (Ø 6÷12 mm) supplied as standard for single cable connection . Isolation: CLASS II . Available colours: Anthracite grey (cod.24). Weight: 18.96 Kg Glow Wire test: -- Exposed windage area : 0,06 m² ( 1000mm ), 0,05 m² ( 800mm ), 0,04 m² ( 645mm )LED circuit included.AVENUE PATENT PENDINGThis luminaire contains built-in LED modules. In case of damage or malfunction please contact the manufacturer to receive additional instructions on how to replace and relative spare parts to order. The LED modules cannot be handled in the luminaire by the end user.LED modules are engineered accordingly to the existing regulations of Lumen Maintenance (LM80) and Technical Memorandum (TM21), where uniformity and quality of the light is 70,000 hours referred to L80 B10 Ta 25 ° C (50,000 hours referable to L80 B10 Ta 40°C). Lifespan of the luminaire > 50,000 hours at 40°C. Performance Ambient temperature Tq 25°C. Operating ambient temperature range is from -20°C to +50°C. Storage temperature range from -20°C to +60°C.

No Rating

Product Version: Revit Architecture 2018

818 Downloads