 |
3-Gang Switch (2 Single Pole Switch; 1 3-Way Switch) w/ electrical conduit connector |
|
Product Version: Revit Architecture 2017
12129 Downloads
|
|
 |
Tower Flow Seperator package with pump, tank and panel. Electrical Panel was made by someone else and pump was also made using Solidworks by someone else. |
|
Product Version: Revit MEP 2018
2292 Downloads
|
|
|
 |
MIFAB® Series MC-26 water closet carrier with lacquered cast iron fitting, 4” (102) no hub waste, 2” (51) no hub vent connection, adjustable 8” tapered thread ABS nipple with integral test cap, neoprene bowl gasket, hardware, threaded rod protectors, polished chrome plated finishing cap nuts and side anchor tie down support. |
No Rating |
Product Version: Unknown
37 Downloads
|
|
|
 |
WATTS carrier ISCA-101 Adjusts for the toilet outlet ht and the 'X' dimension |
No Rating |
Product Version: Revit MEP 2010
1909 Downloads
|
|
|
 |
Basic air seperator with pipe connections outlet, inlet and purge |
No Rating |
Product Version: Revit MEP 2015
1658 Downloads
|
|
|
 |
A switch with an invisible model line at 7', so if you set your RCP cut plane to just below 7', outlet symbols will show up. This one is a switch w/ a dimmer. |
No Rating |
Product Version: Revit Architecture 2008
5952 Downloads
|
|
|
 |
A switch with an invisible model line at 7', so if you set your RCP cut plane to just below 7', outlet symbols will show up. This one is a double switch. |
No Rating |
Product Version: Revit Architecture 2008
7271 Downloads
|
|
|
 |
A switch with an invisible model line at 7', so if you set your RCP cut plane to just below 7', outlet symbols will show up. This one is a switch w/ a timer. |
No Rating |
Product Version: Revit Architecture 2008
2692 Downloads
|
|
|
 |
A switch with an invisible model line at 7', so if you set your RCP cut plane to just below 7', outlet symbols will show up. This one is a single switch. |
|
Product Version: Revit Architecture 2008
8276 Downloads
|
|
|
 |
Inspection Chamber having 3 inlet port and 1 outlet port
(it has been classified as pipe fitting in order to calculate the flow fixture units) |
|
Product Version: Unknown
3190 Downloads
|
|
|
 |
This Family combines a fully realistic renderable Outlet and the capabilities of a MEP Family. Each Receptacle can be scheduled and tied to in MEP. |
|
Product Version: Revit Architecture 2017
4547 Downloads
|
|
|
 |
This Family combines a fully realistic renderable Outlet and the capabilities of a MEP Family. Each Receptacle can be scheduled and tied to in MEP. |
|
Product Version: Revit Architecture 2017
3541 Downloads
|
|
|
 |
It has 2 inlets for hot and cold water, and 1 outlet for mixed water.
It is en Revit 2023 |
No Rating |
Product Version: Revit Architecture 2020
146 Downloads
|
|
|
 |
This Family combines a fully realistic renderable Outlet and the capabilities of a MEP Family. Each Receptacle can be scheduled and tied to in MEP.
|
|
Product Version: Revit Architecture 2017
2374 Downloads
|
|
|
 |
This is my first family and upload. A simple parametric FCU with adjustable height, width and length, also airflow. The airflow will also change in relation of the unit outlet area. |
|
Product Version: Revit MEP 2012
2201 Downloads
|
|
|
 |
This Family combines a fully realistic renderable Outlet and the capabilities of a MEP Family. Each Receptacle can be scheduled and tied to in MEP.
|
No Rating |
Product Version: Revit Architecture 2017
2479 Downloads
|
|
|
 |
This is useful for anyone that works on school projects. This is an "all-in-one" control panel we use for classroom applications, thought I'd share this with the RevitCity community. My model contains a clock, PA speaker, phone, light swtiches, operator switch for PA, duplex receptacle & data outlet; these can be mixed and matched based on your needs. |
|
Product Version: Revit Architecture 2013
5338 Downloads
|
|
|
 |
Series LF40L, LF40XL Automatic Reseating Temperature and Pressure Relief Valves are used in commercial water heater applications to provide automatic temperature and pressure protection to hot water supply tanks and hot water heaters. They feature a Lead Free* brass body with NPT male inlet and NPT female outlet connections, unique thermostat with special thermo-bonded coating, tamper-resistant bonnet screws, automatic reseating feature, and test lever. Model LF40L has a short thermostat for installation directly in available tank tapings. Model LF40XL has an extension thermostat for installation in the hot water outlet within the allowable distance from the top of the tank. Series LF40L, LF40XL valves are ASME rated and CSA listed. Temperature Relief: 210 degreeF (99 degreeC). Pressure Range: 75 to 150psi (5.2 to 10.3 bar). Standard Pressure Settings: 75, 100, 125, or 150psi (5.27, 7.03, 8.79, or 10.55 bar). |
No Rating |
Product Version: Revit MEP 2014
173 Downloads
|
|
|
 |
Series RD-270 epoxy coated cast iron scupper drain with flashing clamp, secured angle grate, and no hub (standard) outlet. |
No Rating |
Product Version: Unknown
525 Downloads
|
|
|
 |
BVN AIR
AC CENTRIFUGAL ROOF FANS
VERTİCAL OUTLET
RADYAL ÇATI TİPİ FAN
DİKEY ATIŞLI |
No Rating |
Product Version: Revit Architecture 2016
992 Downloads
|
|
|
 |
Watts Drainage Products FD-540 epoxy coated parking area drain with fabricated steel body and extra heavy duty 24-1/2 in. x 24-1/2 in. (622 x 622mm) two-section ductile iron grate, and noe hub (standard) outlet. |
No Rating |
Product Version: Revit MEP 2014
1179 Downloads
|
|
|
 |
BVN AIR
AC DIRECT DRIVE ROOF FAN
HORİZONTAL OUTLET
RADYAL ÇATI TİPİ FAN
YATAY ATIŞLI, HARİCİ MOTORLU DAİRESEL |
No Rating |
Product Version: Revit Architecture 2016
942 Downloads
|
|
|
 |
BVN AIR
AC DIRECT DRIVE ROOF FAN
VERTİCAL OUTLET
RADYAL ÇATI TİPİ FAN
DİKEY ATIŞLI , HARİCİ MOTORLU
|
No Rating |
Product Version: Revit Architecture 2016
716 Downloads
|
|
|
 |
Kohler - K-713 Villager Bath with Extra 4" Ledge, Left Outlet |
|
Product Version: Unknown
6383 Downloads
|
|
|
 |
Series FS-500 12 in. (305mm) square x 6 in. (152mm) deep PVC sanitary floor sink with secured grate,and socket outlet. |
No Rating |
Product Version: Revit Structure 2014
234 Downloads
|
|
|
 |
BVN AIR
AC AXIAL ROOF FAN
HORİZONTAL OUTLET
AKSİYEL ÇATI TİPİ FAN
YATAY ATIŞLI |
No Rating |
Product Version: Revit Architecture 2016
574 Downloads
|
|
|
 |
BVN AIR
AC DIRECT DRIVE ROOF FAN
HORİZONTAL OUTLET
RADYAL ÇATI TİPİ FAN
HARİCİ MOTORLU , YATAY ATIŞLI |
No Rating |
Product Version: Revit Architecture 2016
514 Downloads
|
|
|
 |
Series RD-290 epoxy coated cast iron scupper drain with flashing clamp, secured flat grate, and no hub (standard) outlet. |
No Rating |
Product Version: Revit MEP 2014
492 Downloads
|
|
|
 |
BVN AIR
AC CENTRIFUGAL ROOF FAN
HORİZONTAL OUTLET
RADYAL ÇATI TİPİ FAN
YATAY ATIŞLI |
No Rating |
Product Version: Revit Architecture 2016
1406 Downloads
|
|
|
 |
Kohler - K-3546 Barrington Pressure Lite Toilet with 4" Rough-in, Rear Outlet and Left-hand Trip Lever |
No Rating |
Product Version: Unknown
6657 Downloads
|
|
|
Search