I couldn't find a rotating cowl for Revit anywhere so I just figured out how to make it myself. This is a basic non parametric rotating cowl made in Revit 24. My first self made family.

Product Version: Unknown

311 Downloads

Based on post from

https://forums.autodesk.com/t5/revit-architecture-forum/chimney-symbol/td-p/10530717

No Rating

Product Version: Revit Architecture 2017

398 Downloads

this is a fireplace a half octagon shape chimney

it comes with different styles

Enjoy.

Product Version: Revit Architecture 2013

9826 Downloads

Hello Everyone 

here by Im Uploading a Kitchen Chimney Which I Have not found in this site...

Hope You Guys enjoy

01-07-2020

No Rating

Product Version: Unknown

5707 Downloads

Fireplace with adjustable chimney height

Product Version: Revit MEP 2013

24004 Downloads

Metal chimney shroud cap

Product Version: Unknown

2100 Downloads

This is a simple parametric masonry fireplace without chimney.

No Rating

Product Version: Revit Building 9.1

2962 Downloads

Masonry Fireplace Firebox, with smoke chamber and chimney

Product Version: Revit Architecture 2008

9386 Downloads

Roof steps are a simple way to creat an access route, for example, up to a chimney. They may be used on roofs of up to a 4-meter access height with a pitch of a 45 degrees.

They are installed in a straight line one over the other are finished off with anchoring device for personal fall protection, for example , a rdige rail.

Made in Sweden by CW Lundberg AB

No Rating

Product Version: Revit Architecture 2018

497 Downloads

Facade ladder for evacuation, ascending to the roof and chimney.

Installed with a bracket depending on the depth of the roof foot. Handrails shall be installed with a bracing kit on facade ladders and on roofs or other permanently installed access device.

Satisfies the requirements set out in SS 831340

Made in Sweden by CW Lundberg AB

No Rating

Product Version: Revit Architecture 2018

781 Downloads

This is a fully parametric fireplace mantle and Isokern Magnum fireplace.  Included are several nested families:  the mantle, the Isokern Magnum Series 28, 36, 42, and 48, and The Isokern DM54 Chimney system.  Also included is the Isokern Offset Block.  As this family uses family types for the fireplace, the firebox parameters are no longer available.  There is a brickledge visibility parameter but no veneer above the ledge.  I figured this was project specific.

Set flute depth to 0" to make flutes not visible.  I could not get the flutes to array properly, so when adjusting side piece width you will have to edit the family and copy/paste/delete the void extrusions to get the desired number.  Flute size is adjustable.  Remember to lock the extrusions to the sweep shape handle.

Suggestions are welcome.

Product Version: Revit Architecture 2011

14086 Downloads

Roof steps are a simple way to creat an access route, for example, up to a chimney. They may be used on roofs of up to a 4-meter access height with a pitch of a 45 degrees.

They are installed in a straight line one over the other are finished off with anchoring device for personal fall protection, for example , a rdige rail.

Made in Sweden by CW Lundberg AB

No Rating

Product Version: Revit Architecture 2018

259 Downloads