MIFAB® Series F1510 lacquered cast iron floor drain with deep sump body, wide anchor flange, weepholes, and adjustable collar with square heavy duty ductile iron hinged tractor grate with four piece surface membrane clamp, sediment bucket and free area of 51 in² (32,903²).

No Rating

Product Version: Unknown

209 Downloads

Roof steps are a simple way to creat an access route, for example, up to a chimney. They may be used on roofs of up to a 4-meter access height with a pitch of a 45 degrees.

They are installed in a straight line one over the other are finished off with anchoring device for personal fall protection, for example , a rdige rail.

Made in Sweden by CW Lundberg AB

No Rating

Product Version: Revit Architecture 2018

258 Downloads

MIFAB® Series MI-ELB (specify size) of flexible rubber elbow couplings are manufactured from a flexible PVC that meets the requirements of ASTM C-564 and Type 300 Series of stainless steel clamps tightened (to 60 lbs. torque) with 5/16” Type 300 stainless steel hex head screws. The MI-ELB Series of flexible couplings are listed with I.A.P.M.O. Non constant temperature rating is 140 F.

No Rating

Product Version: Unknown

253 Downloads

MIFAB® Series MC-40 floor mounted exposed arm lavatory carrier with white, lacquered, adjustable, cast iron exposed support arms. Complete with lacquered cast iron invertible and adjustable arm supporting brackets, alignment rod, two lacquered 2” x 1” x 1/8” thick structural steel uprights with 3” x 4 ½” welded steel feet and mounting hardware.

No Rating

Product Version: Unknown

27 Downloads

MIFAB® Series MC-40 floor mounted exposed arm lavatory carrier with white, lacquered, adjustable, cast iron exposed support arms. Complete with lacquered cast iron invertible and adjustable arm supporting brackets, alignment rod, two lacquered 2” x 1” x 1/8” thick structural steel uprights with 3” x 4 ½” welded steel feet and mounting hardware.

No Rating

Product Version: Unknown

15 Downloads

This casework family is over the top!  There are the usual casework dimensions, but in addition, there are instance parameters to open the doors, pull out the top drawer, and slide out the two shelves hidden behind the doors, all individually controlled.  There are dedicated materials assigned by casework subcategories.  The model is replete with pots and pans sitting on the sliding shelves.  There are ten predefined widths.  At the narrower sizes, you'll see the pots and pans sticking out through the cabinet sides, so if you want, for instance, a 21" unit, you'll have to edit the family to remove or reposition them.  The unit is modelled on the American Woodmark line of cabinets.  The properties URL will take you to the American Woodmark web site.  This is a complex model.  I have tested it thoroughly, but if there are any difficulties, please leave a note for me.

I have updated this model.  It has more subtle engraving on the doors, curved handles, and the doors open more reliably.  Open them in angular increments of something less than 90°.  For example, if you want them opened to 90°, do it in two operations with the first angle 70° and the next 20°.  Close them the same way.

Product Version: Revit Architecture 2013

7499 Downloads

MIFAB Series FS1940-FL, 12” x 12” x 10” deep 16 gauge, All Type 304 (CF8) stainless steel sanitary floor area and indirect waste drain complete with cast stainless steel secured rim and grate with allen key vandal proof stainless steel screws, stainless steel anchor flange with weepholes and anti-splash dome strainer.

No Rating

Product Version: Unknown

38 Downloads

MIFAB® Series R1100-JC lacquered cast iron roof drain with anchor flange, cast iron waterproofing membrane clamp ring with integral gravel stop, 6” (152) high stainless steel perforated ballast guard with ½” (13) round drainage openings and standard self-locking polyethylene dome strainer with a free area of 43 square inches.

No Rating

Product Version: Unknown

108 Downloads

MIFAB® Series F1100-C-ER( )-1 lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and extended rim (specify diameter), satin finished nickel bronze strainer with vandal resistant, stainless steel allen key screws. (For non-membrane floors, use MIFAB F1100-ER Series.)

No Rating

Product Version: Unknown

11 Downloads

MIFAB® Series MI-FLEX (specify size) of flexible rubber couplings are manufactured from neoprene compound that meets the requirements of ASTM C-564 and 300 Series of stainless steel clamps tightened with 5/16” Type 300 stainless steel hex head screws. MI-FLEX Series of flexible couplings are tested and certified to ASTM Standard 1173-2010 and CSA Standard B602-2016 and listed with I.A.P.M.O.

No Rating

Product Version: Unknown

129 Downloads

MIFAB® Series F1100-C-EF lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and standard 4” (102) round (specify strainer finish) bronze funnel assembly with vandal resistant allen key screws. (For non-membrane floors, use MIFAB F1100-EF Series.)

No Rating

Product Version: Unknown

16 Downloads

MIFAB® Series MI-SD____ sanitary epoxy coated inside and outside fabricated 10 gauge steel sand interceptor. Unit shall include: removable cross bar, four 3" (76) threaded vent connections, solid straining baffles, stainless steel calibrated orfice plate, securing bolt(s), sediment bucket with perforated baffle beside inlet, deep seal trap, sewer gas stopper, internal air relief by-pass, and steel powder epoxy coated non skid rectangular gasketed lid(s).

Product Version: Unknown

213 Downloads

MIFAB Series FS1920-FL, 12” x 12” x 6” deep 16 gauge, All Type 304 (CF8) stainless steel sanitary floor area and indirect waste drain complete with cast stainless steel secured rim and grate with allen key vandal proof stainless steel screws, stainless steel anchor flange with weepholes and anti-splash dome strainer.

No Rating

Product Version: Unknown

34 Downloads

MIFAB Series FS1930-FL, 12” x 12” x 8” deep 16 gauge, All Type 304 (CF8) stainless steel sanitary floor area and indirect waste drain complete with cast stainless steel secured rim and grate with allen key vandal proof stainless steel screws, stainless steel anchor flange with weepholes and anti-splash dome strainer.

No Rating

Product Version: Unknown

37 Downloads

MIFAB® Series MI-OS ___ (specify model) sanitary powder epoxy coated inside and outside fabricated 10 gauge steel oil / sediment interceptor with sludge capacity of ____ lbs. (specify). Interceptor complete with ANSI rated “Special Duty” ductile iron grate(s) with load rating over 10,000 lbs., removable sediment bucket and mud pan, deep seal trap with integral sewer gas stopper, internal vent system, cleanout plug and side outlet.

No Rating

Product Version: Unknown

138 Downloads

MIFAB® Series F1100-C-ER( )-1 lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and extended rim (specify diameter), satin finished nickel bronze strainer with vandal resistant, stainless steel allen key screws. (For non-membrane floors, use MIFAB F1100-ER Series.)

No Rating

Product Version: Unknown

12 Downloads

MIFAB® Series F1100-C-ER( )-1 lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and extended rim (specify diameter), satin finished nickel bronze strainer with vandal resistant, stainless steel allen key screws. (For non-membrane floors, use MIFAB F1100-ER Series.)

No Rating

Product Version: Unknown

12 Downloads

MIFAB® Series F1100-C-FC( )-1 lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and “FC” (specify diameter) round, reinforced satin finished nickel bronze strainer with surface membrane clamp and vandal resistant, allen key screws. (For non-membrane floors, use MIFAB F1100-FC Series.)

No Rating

Product Version: Unknown

53 Downloads

MIFAB® Series MI-SAND/OIL____ sanitary powder epoxy coated inside and outside fabricated 10 gauge steel sand and oil interceptor with a holding capacity of - see chart below. Interceptor complete with gasketed non-skid powder epoxy coated lid, removable sediment bucket with perforated baffle beside inlet, deep seal trap with integral sewer gas stopper, two 2” vent connections, adjustable oil draw off assembly and no hub inlet/outlet.

No Rating

Product Version: Unknown

231 Downloads

MIFAB® Series R1150 combined roof drain and secondary overflow system, consisting of a galvanized sump receiver; two lacquered cast iron roof drain bodies with anchor flanges, cast iron waterproofing membrane clamp rings with integral gravel stops, one 4” (102) diameter adjustable ABS overflow standpipe and two self-locking metal dome strainers with a free area of 43 square inches each.

No Rating

Product Version: Unknown

1146 Downloads

This is the finished Facility Occupancy Load Schedule and Egress Plan. This is automated to calculate the occupant load based on the type of area then use that to calculate occupant load.

There are 2 tags. 1 for rooms, 1 for egress doors.

There are 4 schedules

1.      DOOR EGRESS SCHEDULE

2.      FACILITY OCCUPANCY SCHEDULE

3.      ROOM OCCUPANCY COMPARE SCHEDULE

4.      SPACE OCCUPANCY CLASSIFICATION

There is one sample Model.

Steps:

1.      Copy the schedules and tags to your current project.

2.      Open the Room occupancy compare schedule

3.      Select what type of area you see fit.

4.      Type in 0 sf for “NON CALCULATED ROOM AREA” to calculate occupants

5.      Manually type in tag value to match calculation to populate the room tag.

6.      Place the facility schedule on the code plan sheet.

7.      Place the Door egress schedule on the sheet too.

8.      Place all your room tags

9.      Place your egress door tags on 1 exit way door only per egress area

10.   Make a note of how you want to number your egress areas. ( I usually go clockwise from upper left to lower right)

11.   Fill in the Egress area for each room in the properties field. ( You can multiple select rooms at the same time and type in the value for all at once, use your filter)

12.   The Facility Schedule will populate.

13.   Type in the Occupant value to the Door egress schedule. Make sure they match. Hide Door egress schedule.

You’re done. Or pretty close J #JustinDesigns3D JustinDesigns3D@Gmail.com

Product Version: Unknown

4005 Downloads

MIFAB® Series F1100-C-T(*)-3 (* specify strainer diameter) lacquered cast iron floor drain with anchor flange, cast iron membrane clamp with primary and secondary weepholes for waterproofing membrane, and heavy duty, solid, gas tight, spanner wrench, vandal proof, stainless steel cover for secured access. (For non-membrane floors, use MIFAB F1100-T Series.)

No Rating

Product Version: Unknown

34 Downloads

MIFAB®  C1100-S Series adjustable floor cleanout with lacquered cast iron body and anchor flange, secondary “O” ring Test Seal, 4” diameter cleanout opening and square scoriated combined cover and plug top assembly (specify material type) with stainless steel vandal proof allen key screws and primary gasket seal. (For membrane floors, add Suffix -C for the membrane clamp.)

No Rating

Product Version: Unknown

111 Downloads

MIFAB® Series R1200-PR15” lacquered cast iron deep sump roof drain with 15” diameter anchor flange, large cast iron waterproofing membrane clamp ring with integral gravel stop, square adjustable collar and standard 15” (381) square ductile iron tractor grate with 3/8” (9) maximum width drainage slots and a free area of 80 square inches.

No Rating

Product Version: Unknown

170 Downloads

MIFAB® Series F1100-C-EG lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and standard 4” (102) x 9” (235) oval (specify strainer finish) open throat funnel with vandal resistant, stainless steel allen key screws. (For non-membrane floors, use MIFAB F1100-EG Series.)

No Rating

Product Version: Unknown

15 Downloads

MIFAB® Series F1100-C-EG lacquered cast iron floor drain with anchor flange, cast iron membrane clamp ring with primary and secondary weepholes for waterproofing membrane, and standard 4” (102) x 9” (235) oval (specify strainer finish) open throat funnel with vandal resistant, stainless steel allen key screws. (For non-membrane floors, use MIFAB F1100-EG Series.)

No Rating

Product Version: Unknown

16 Downloads

MIFAB® Series R1250 lacquered cast iron extra deep sump high flow roof drain with 15” diameter anchor flange, large cast iron waterproofing membrane clamp ring with integral gravel stop, and standard self-locking polyethylene dome strainer with a free area of 125 square inches.

No Rating

Product Version: Unknown

75 Downloads

MIFAB® Series MI-SOLID-SA side access Type 304 14 gauge stainless steel solids interceptor with internal stainless steel perforated sediment bucket connected to a removable and gasketed side access latched lid. Interceptor complete with 2” female threaded inlet, 2” female threaded outlet on each side for right or left hand installation and internal stainless steel flow control.

No Rating

Product Version: Unknown

23 Downloads

MIFAB® Series R1200-G lacquered cast iron deep sump roof drain with 15” diameter anchor flange, large cast iron waterproofing membrane clamp ring with integral gravel stop, 6” (152) high stainless steel perforated ballast guard with ½” (13) round drainage openings and standard self-locking polyethylene dome strainer with a free area of 125 square inches.

No Rating

Product Version: Unknown

68 Downloads

MIFAB®  C1100 Series (specify top assembly design) adjustable floor cleanout with lacquered cast iron body and anchor flange, secondary “O” ring Test Seal, 4” diameter cleanout opening and scoriated combined cover and plug top assembly (specify material type) with stainless steel vandal proof allen key screws and primary gasket seal. (For membrane floors, add Suffix -C for membrane clamp.)

No Rating

Product Version: Unknown

62 Downloads