Forums >> Revit Building >> Technical Support >> Wall Sweep ending at roof slope/roof line

rcobbjr

active

Joined: Thu, Jul 26, 2007
79 Posts

I am using hardiplank siding on a residential building in Revit 2008. I used a wall sweep to put the siding on the wall. When I put the siding on the wall it runs horizontally from wall to wall, it is fine. When I get the part of the wall that ends with the roof slope, the siding does not "cut" at the same angle as the roof line. What do I need to do in order for the siding/sweep to merge into the the roof line and cut at the same angle as the roof slope?

This user is offline

Modelling terrain Revit imported from AutoCad

1

3D PDF and PRC supports the following data

0

schedule - item count

1

RevDev Studios - RevEx and RevXL - Spreadsheet plugins for Revit

0

I Can't use RPC content in Revit Architecture 2011

0