Forums >> Revit Building >> Technical Support >> Elevation shows as section

JHanby

active

Joined: Thu, May 25, 2006
177 Posts

Revit 9.1.  I have my building model linked into the site model.  The elevation mark was located inside the building and was showing as a section.  I moved the elevation mark to the outside of the building however the elevation is still showing up as a section.  How can I fix this?  I tried to delete the mark and make a new elevation view buy then the linked model doesn't show up in that view.  Need to print my sheet by tomorrow morning.  Thanks.

This user is offline

View Website

JHanby

active

Joined: Thu, May 25, 2006
177 Posts

Edit is still not working.   

Made a temporary fix by placing a section mark outside the building to get an elevation view but would still like to know the solution to the problem.

This user is offline

View Website

coreed

site moderator|||

Joined: Fri, Feb 10, 2006
1874 Posts

under VG check that your walls are turned on in that view

also click on the tip of the elevation mark you should see an horizontal line that define the view extents make sure that line is out side the building

-----------------------------------

best regards,

coreed,aia

bmpArchitects,Inc.

"Revit has to be implemented, Not installed." 

Long Live Revit

This user is offline

When I cut a section or elevation in revit, it shows what's behind the cut plane

4

Section cut material shows up grey instead of brown

1

topography in elevation shows up "blank" space. any work around?

12

Section and interior elevation missing from file once it is linked

1

Turn off section references that occur in the background of an elevation

2