Forums >> Revit Building >> Technical Support >> cut symbol on stairs

terealva

active

Joined: Wed, May 16, 2007
21 Posts
No Rating

Is there a way to change where the cut on the stairs is done?

The building that I'm working on has a part at level 720' and another one at level 722'. When I show this as a whole floor plan my stairs are being cut at different locations. So the stairs that are related to level 722' are just showing about 3 steps and the stairs related to level 720' are showing about 6 steps. I would like them both to show the same amount of steps.

Is there a way to get around this?Thanks,Terealva.

This user is offline

FrankyDHalliday

active

Joined: Sat, Dec 3, 2011
29 Posts

Is either adding a plan region and changing the cut height or simply in the properties pallette for that view changing the view range parameters going to solve your issues?

-----------------------------------

Dr. Zaius: Ah, yes - the young ape with a shovel. I hear you're planning another archeological expedition. Cornelius, a friendly word of warning - as you dig for artifacts, be sure you don't bury your reputation. 

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I think you answered your own question - plan region.

This user is offline

Stairs and plan regions (cut height)

4

2013 stair path symbol for component stairs displays differently

2

Revit 2013 - Cut Wall under stairs.

1

Plan Region & stairs

9

Stair - Cut Profile

2