Forums >> Revit Building >> Technical Support >> diffrent wall thickness

Unknown

active

Joined: Sun, May 21, 2006
5 Posts
No Rating

Hello everybody,

 i will reconstruct an old building, but the walls are not parallel. For exampel the beginning of the wall have a thickness of 10 inches but the end is only 9 inches. How is it possible to make a wall with a diffrent wall thickness in the ground plan.

Can anyone help me?

This user is offline

coreed

site moderator|||

Joined: Fri, Feb 10, 2006
1874 Posts

try reviewing this link and look at wall.doc  document post by arnosondoval

it should help solve you problem. but it comes down to creating an in-place family, choose wall for your category, so that your mass behaves as a wall and then using extrusion to create the wall. that sort of summaries the link below. but i  would review all the posts in the link.

http://www.revitcity.com/forums.php?action=viewthread&thread_id=1198

HTH

-----------------------------------

best regards,

coreed,aia

bmpArchitects,Inc.

"Revit has to be implemented, Not installed." 

Long Live Revit

This user is offline

Unknown

active

Joined: Sun, May 21, 2006
5 Posts
No Rating

This user is offline

Hatch patten lineweights for duct

1

Wall Thickness in Type Parameter

5

Wall Thickness variable

8

Variable Thickness Wall?

4

Revit 2013 - Window frame sweep with wall thickness

4