Forums >> Revit Building >> Technical Support >> Sweeps in all 3 directions?

boydj

active

Joined: Fri, May 19, 2006
46 Posts
No Rating

How can I create a sweep in all 3 directions.   What I'm trying to do is show a roof drain coming out of the ceiling and the path that it travels before it goes through the floor somewhere elese in the building.  Sometimes it drops vertically, sometimes it runs parallel to the ceiling....may turn left, may turn right before turning down into the floor. 

From what I can see...the "path" is only in two directions.

Thanks

This user is offline

bolandereric

active

Joined: Mon, Dec 13, 2004
61 Posts

This user is offline

thundercad

active

Joined: Thu, Nov 9, 2006
18 Posts
No Rating

I dont know how you can create in place library using 3D path for sweeping as the path is limited into 2D plane (work plane). If it can be done, would you please give some more concrete hint to make path in all 3D directio? Also, I may want to imort a 3D path from other soteware, but revit dont allow me to use that imported path (or profile) to do sweepping. Is there any way to use imported path (profile) when using in place modeling creation?

This user is offline

Ceilings sloped in two directions?

6

Pilasters with sweeps/reveals

4

Rendering in different directions

3

Sloping floors in two directions

3

Skylight with slopes in 2 directions

1