Forums >> Revit Building >> Technical Support >> Joining extrusions

ennisdavis23

active

Joined: Fri, Jun 26, 2020
0 Posts
No Rating

I am trying to join 3 extrusions similar to a teepee so that they come to a point. I created the 3 extrusions in a generic model and there are limited trim options in that family generator.

This user is offline

marmiketin1

active

Joined: Wed, Aug 19, 2015
0 Posts

Please provide a picture of what you have tried. Almost any shape can be created with a bit of though using extrusions and voids to cut them.

This could also be done using a blend going from a large triangle at ground level up to a small triangle at the top.

This user is offline

a few issues i need help with (drainpipes, joining walls)

1

Roof Joining Issue

12

naming extrusions

3

Extrusions within a project? (2010)

5

highrise towers slabs-walls joining

5