Forums >> General Discussion >> Revit Project Management >> Automatic infill phasing

aaronkennedy

active

Joined: Wed, Jul 9, 2008
109 Posts

Is there a way to change the phase of an automatic infill?

Background.  On a renovation project my typical phases are, existing, demo, & new.  My phase settings for new construction is "Show Previous + New".  This way existing to remain items are gray line / course detail level and new items are black line, medium detail level. 

My problem: When I demo a door in the demo phase, the infill take place in the demo phase and shows up as gray / course in the new constrution.  I would like it to show up black / medium. 

If I demo in new construction and have the phase setting at show previous + new the infill shows up as new (black/medium).  

Any thoughts?

Thanks

AAron

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

aaron,

Please read my post here: https://www.revitcity.com/forums.php?action=viewthread&thread_id=35001

This user is offline

aaronkennedy

active

Joined: Wed, Jul 9, 2008
109 Posts

Thanks,

Digging in the way back for that that one.

This user is offline

Phasing / Floor Infill

2

Infill walls and phasing

10

Wall and Instance phasing warning - Incorrectly Reporting?

4

infill wall alignment to host wall

2

Unwanted outlines on automatic wall infill

1