Forums >> Revit Building >> Technical Support >> Trouble with Sweep along multiple planes

RNJ123

active

Joined: Mon, Sep 17, 2018
0 Posts
No Rating

I'm trying to make a railing profile sweep that follows a path along a vertical plane that eventually goes into a diagonal plane.  I keepgetting the error message saying "more than one loop not allowed".  I have checked to see if there are any hidden interesecting lines along the path and it's all good.  

If anyone can offer some suggestions it would be much appreciated!

I've attached the drawing in question.

This user is offline

ers01

active

Joined: Tue, Jun 6, 2017
0 Posts
No Rating

Your horizontal line and corners do not quite connect.

This user is offline

Multiple Curves and Angles with Sweep

4

sweep on spline in different planes

7

Can You Flex a Sweep in Components

2

Sweep Profiles in Version 9

0

Twisting 3D sweep [ 1 2 ]

17