Forums >> Revit Building >> Technical Support >> Adjust Brick veener to move down agianst the brick ledge.

1bchristian

active

Joined: Sun, Apr 22, 2018
0 Posts
No Rating

Revit 2017 - I have a problem when I stretch the brick veener to meet the brick ledge and then go back to plan the exterior walls do not fillet

properly anymore - is this correct or am I doing something wrong? I have attached a image - Thank you Byron  

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Revit will always do this when you adjust a layer on one side of an intersection.  It doesn't know what to do when the two sides are not the same.   

This user is offline

Rescue5Heroes

active

Joined: Thu, Jun 15, 2017
0 Posts
No Rating

Have you also tried to adjust the join order of the two walls? So that your left wall is extended to the edge of your top wall.

This user is offline

Uncreatedbody

active

Joined: Sun, Jul 20, 2014
0 Posts
No Rating

How is your brick veener being used in your model? Part of the wall make-up/construction or as a wall sweep? Check if the brick veneer is selected to wrap when you edit the structure.

These walls that intersect are the same construction, correct?

This user is offline

1bchristian

active

Joined: Sun, Apr 22, 2018
0 Posts
No Rating

Yes both walls or all exteriro walls are identical. This was correct then it happened when I stretched my brick down to the brick ledge. the brick is in the wall mek up.

This user is offline

Brick Ledge?

4

Brick Ledge Question in RAC 2011

2

Why won't my brick ledge show in plan

1

CMU + brick wall- brick is NOT bearing

3

Brick or Stone Overhang

3