Forums >> Revit Building >> Technical Support >> turning off hatch pattern of certain wall layers

brankulo

active

Joined: Mon, Dec 7, 2015
0 Posts

i have a wall which consists of stucco over rigid foam on 2x6 studs with gyp interior. all these layers have hatch assigned to them.

now how do i achieve the following:

in floor plans i dont want to see any hatching except rigid foam.

in sections i want to see all hatching except 2x6 stud layer.

is this even possible? in VG, i am only able to turn on/off hatch for all wall layers together.

thanks

This user is offline

broadtechengineering

active

Joined: Sat, Dec 30, 2017
0 Posts
No Rating

Hi BrankuloI briefly wen through your requirements. I think I can help you with that

-----------------------------------

BroadTech Engineering | Your Trusted Engineering Simulation Company

This user is offline

View Website

Seperating layers hatch with filter

10

Turning brick hatch pattern off in a wall section.... is it possible?

5

Vertical hatch pattern line alignment on wall ends

2

CMU Hatch Patern

4

Getting Cut Wall Hatch to move WITH the Wall

1