Forums >> Revit Building >> Technical Support >> Surface on solid form getting split after being edited by a void form

jkeefe22

active

Joined: Wed, Aug 9, 2017
0 Posts

Thanks is advance to anyone who helps. I'll get right to the issue:

In Revit 2016, I have created an in-place mass (that is a 3D form) that in plan, looks like a distorted rectangle (its curved). I have made an additional void form in the mass to make the top of the mass have a surface that sweeps up in one corner. While this resulted with one form, the top surface was split into two: one that is flat, and a corner that curls up. 

What I need is to be left with ONE top surface that is flat at first, then curls up in the corner. I have created a custom UV grid and I want it to follow the top surface as it curls up. (The desired custom UV grid is overlayed on the form)

I need the top surface to be a single piece so that when I put adaptive curtain wall panels onto the UV grid, there is no kink where it starts to bend up. In other words, I need the transition from the flat section of the surface to the curled section to be seemless (like the rest of the curve).

Thanks again for any help.

This user is offline

void form and cuttng void form

0

Void form issues once again. Few question

3

VOID form will NOT work! [ 1 2 ]

22

Can you apply divide surface to a revolved form?

2

Creating Family's - Hatching of Solid Form

0