Forums >> Revit Building >> Technical Support >> generic model cutting issue 2016

sllana

active

Joined: Wed, Mar 2, 2011
106 Posts

I made a generic model (that is not in the list of non-cuttable-families in the help) made up of 2 materials in a sandwich alike configuration and the edges also covered (core of concrete and top, bottom and edges of wood) all with equal visibility settings, and when generating a transversal section through it, both parts are correctly shown but when sectioning it logitudinally, it only shows one material (the exterior one) and not even show the divisory line between them. Any idea why?

Thank you very much.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Sorry but your question is confusing.  An image showing the item and where the section is cut may help.  I can understand that when you cut transvers, you are cutting through both materials and you see them but in the other direction, you would only be cutting throgh one or the other.

This user is offline

sllana

active

Joined: Wed, Mar 2, 2011
106 Posts

No, in the other direction it is also cutting through both materials.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

We need images....

This user is offline

Generic Model behind Section Cut.

1

generic model family not cutting in section

8

Window not cutting wall

2

Convert Generic Model floor based Generic -> Generic Model

2

Issue with annotation nested with generic model family

5