Forums >> Revit Structure >> Technical Support >> Using Client's Coordinates and Scheduling Columns To Show Locations

jpw2913

active

Joined: Tue, Jan 29, 2013
2 Posts
No Rating

Hi All,

We have a large plan (it's a gas plant) that we have done the foundations for.  The client wants to use their own specific coordinates for the plan and wants us to provide a schedule of the columns (piers really) showing their locations using their coordinates.  For example column #1 - located at N. 250'-3", W. 152'-6".  There are A LOT  of these columns that need to be located in the schedule.  Is there a way to just set the coordinate system in the plan so that the schedule will automatically populate the proper coordinates for each column?  Hope the question makes sense.  Thanks for any advice!!

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

This can be done and has been discussed before but you must have your project setup correctly to report locations.   I'll try to look through discussions here to see what there is here at RC.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I looked in the app store on the Autodesk site and it appears that there are several apps that will do this.  The first says:

This user is offline

Schedule columns coordinates

11

columns don't show up in section elevations

2

specify coordinates at a point

1

Are you using SHARED locations?

0

Showing columns from the floor above

5