Forums >> Revit Building >> Technical Support >> Custom Wall Trim

mattanddumber

active

Joined: Mon, Feb 11, 2013
0 Posts
No Rating

I was wondering if someone could point me in the right direction for doing the exterior trimwork around this front door (http://cdn.decorpad.com/photos/2011/05/28/8e3271cb6082.jpg). Sorry for the quality of the image... I'm pretty sure I need to just create an in-place wall and then either create an extrusion or sweep, but I can't get it to work.

Also while I'm on the subject, does anyone know how to create those corbels and/or keystone from the same image?

Thanks

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

All of it can be done in-place including a void sweep if the wall steps back at the door as I think it does.

Do your in-place using an elevation view and set the work plane as the face of your wall.

This user is offline

Custom Wall Cleanup tool

7

RAC 2012: Window Trim Reveal in brick/Stud Wall

3

wall trim under an eave

3

Stone wall covers door and window trim?

6

Trim and frame does not adjuts to wall as expected

4