Forums >> Revit Building >> Technical Support >> MISSING GRID LINE IN TWO FLOOR PLANS ONLY

KYLIEBRAITHWAITE

active

Joined: Wed, Aug 6, 2014
0 Posts
No Rating

Hi,

I have numbered grid lines in my project but on two floor plans (B1 + B2) the grid line no. 16 is missing. It can be seen in all other plans, elevations and sections.

I have tried 'visibility graphics' and 'reveal hidden items'. But no luck! 

Any other ideas?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Are these floors in the middle? - I bet not.   Grids have extends and if they don't intersect the view (either in plan or in elevation), they will not show.  You will have to correct that.

This user is offline

KYLIEBRAITHWAITE

active

Joined: Wed, Aug 6, 2014
0 Posts
No Rating

YOU ARE RIGHT, Q16 IS MISSING ON THE BASEMENT LEVELS.

I SELECTED THE Q16 GRID (FROM AN UPPER LEVEL) THEN I CLICKED 'PROPAGATE EXTENTS' AND SELECTED THE VIEWS I WANT THE GRID LINES TO BE VISIBLE IN.

Q16 IS STILL MISSING?>

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

If this is a lateral problem, find a view where it does show and drag the end (3D) over into the area where it should be.  If it is a verticle problem, use a section or elevation view and drag it there. We are talking 3D here - not 2D ends.

You can use scope boxes too but that is too confusing at first.  This Help section may help you:

http://help.autodesk.com/view/RVT/2014/ENU/?guid=GUID-4E36EDA0-2F4E-4619-B568-AC758E8D9770

This user is offline

KYLIEBRAITHWAITE

active

Joined: Wed, Aug 6, 2014
0 Posts
No Rating

thank you WWHUB!

THAT WORKED. I WENT INTO AN ELEVATION AND DRAGGED THE Q16 GRID LINE DOWN TO THE LOWER LEVELS.

THANK YOU

This user is offline

Column Grid line missing when printing

1

Grid Bubble Control in Different Views

2

Missing Grid Lines

8

Grid lines moving together in different floor plans

3

Missing Grid Lines ...again

1