Forums >> Revit Systems >> Technical Support >> Location of Pipe

sagboy

active

Joined: Mon, Oct 31, 2011
7 Posts
No Rating

Dear All

I am a newbie in Revit System. I use Revit V2014 when i create Pipe for SAN system. I set up VERTICAL JUSTIFICATION to Bottom and i setup reference level -800 from level.

When i check by section the dimention is show number in difference as i set it up. If i back to select Pipe to change to -800. The dimension in section as i create is shown in wrong value as i create in pipe property.

Have anyone can explain for me please how come is show like that.

Note: The image i attach is shown step what i did.

Thank you very much for your kind.

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I'm pretty sure that since all pipes are centerline controlled that the offset property is always to the centerline.

http://help.autodesk.com/view/RVT/2014/ENU/?guid=GUID-54B16217-68F4-4F0C-928C-505690B44EFB

This user is offline

sagboy

active

Joined: Mon, Oct 31, 2011
7 Posts
No Rating

WWWHub

Thank you for your kind for explain for me. That is make me crystal clear for develop my skill.

Billion Thanks.

This user is offline

Labeling/Schedule Piping per Room Location

1

Trim HSS Round pipe into another HSS Round pipe

2

pipe dimensions

4

Pipe Accessories and Pipe Type parameter

3

Pipe Branch Takeoff/Gain

1