Forums >> General Discussion >> Revit Project Management >> Revit lineweights

ESBP

active

Joined: Mon, Jun 30, 2014
0 Posts
No Rating

Does anyone know how to remove lineweights?  For a presentation, some lineweights in my model were changed using the lineweight (LW) command.  I need to create some images from my 3D view, but those altered lineweights show up through the model (even through walls they are supposed to be "behind").  The only way I've found to remove those lines is to give them a lineweight of 0, but then they don't show up in other angles.

In the attached image I've highlighted the lines in questions.  I shouldn't be able to see them through the wall, but because the lineweights were changed now they show up regardless of their relative location.

Any suggestions?

Attached Images

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Use the LW tool and use the <By Category> to turn them back to how they were.  You can also drag the ends of the lines as soon as you change them there will be a blue grip you can drag.

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I doubt those were linetool lines.   I bet they are really lines (3D).

This user is offline

Lineweights Issue

6

Lineweights Question

3

Revit Lineweights not printing correctly

2

revit 2008_ lineweights in 3d views vary.

1

Revit templates with Lineweights set

6