Forums >> Revit Building >> Technical Support >> How would you proceed

Yakarch

active

Joined: Tue, Feb 1, 2011
0 Posts
No Rating

Not sure if I'm posting this in the correct place.

I'm trying to figure out the best way to proceed.  I have built my model in Revit 2015 and after a cost estimate coming in over budget there are now changes that need to be made.  Initial model has masonry exterior walls, a combination of brick and CMU.  The change is one elevation will now be stucco as the base bid and the masonry will be an alternate.  This means I will to have two elevations on my drawings, one showing the stucco and one showing the alternate with masonry. 

So my question is how is the best way to go about this? Is there a good way to model this or should I just model one and use lines to draw the other one? 

Thanks for any input.

This user is offline

coreed

site moderator|||

Joined: Fri, Feb 10, 2006
1874 Posts

Check out Design Options.

-----------------------------------

best regards,

coreed,aia

bmpArchitects,Inc.

"Revit has to be implemented, Not installed." 

Long Live Revit

This user is offline

Transition from AutoCad to Revit - Looking for info, ideas for how to proceed

1

Phasing / Floor Infill

0

How do you chamfer two different wall types?

0

Overall Plans and Partial Plans ... looking for Best Practice

0

Reviosion Cloud Editing?

0