Forums >> Revit Building >> Technical Support >> linework tool - original showing up next time I open revit project

ledgewood33

active

Joined: Wed, Jan 27, 2010
34 Posts
No Rating

I have window elevations where I hide the casing (trim) around the window with the linkwork tool using <invinsible> lines. and it seems as though next next I have to open the project the lines that I hide with the linework tool have reverted back.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I have never seen that happen.

Remember, the linework tool is 2D and view dependent.  ONLY the view it was used in.  Also, you may have multiple elements in the same place.  Typically you will make the one invisible and then the next one shows.  NOTE - If you change the view depth, other elements may show up in the same place.

This user is offline

ledgewood33

active

Joined: Wed, Jan 27, 2010
34 Posts
No Rating

I havent changed a thing relating to the view. I will use the linework tool and save & close and the next time I open the project the lines are back from being invisible

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

SInce you have not shared what Revit and what updates you have installed, you have probably wasted some time.  This is probably an update issue.

This user is offline

ledgewood33

active

Joined: Wed, Jan 27, 2010
34 Posts
No Rating

sorry,

I am in Revit 2015 and have the latest update release 3

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Create the smallest file you can with a wall and the window in it - purge and compress then test to see if you still have the problem.  If so, then post the file so we can look at it.

This user is offline

Linework tool issue

5

linework tool - showing through?

2

Revit 2014 - floor transparency and the linework tool

4

Linework Tool (LW)

2

Using the Grid tool Crashes Revit every time

0