Forums >> Revit Building >> Technical Support >> Help with stringers with landing

ericlovell

active

Joined: Mon, May 10, 2010
14 Posts
No Rating

I drew these stairs in the traditional way by drawing the run with the borders and such already figured out. The stairs tapper as the go up and have a landing in the middle of the stairs. The stringers need to run parallel with the stairs, but I can't figure out how to get the stringer to go horizontal at the landing and then pick up the slope again. These are exisiting stairs that we are putting an addition below for. I need help for my office. I am using Revit 2014. The left side is somewhat of what I want, but it's not horizontal. I can't figure it out

Attached Images

This user is offline

ericlovell

active

Joined: Mon, May 10, 2010
14 Posts
No Rating

I also need the stringer to extend past the stairs at the top. I am not sure if it needs to be more of a railing or a stringer, but it needs to got above and below the actual stairs themselves so I did a stringer.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Read your HELP again:

http://help.autodesk.com/view/RVT/2015/ENU/?guid=GUID-6C4F7A35-F62B-49A4-92C4-73E9610CA6C8

and you will see this:

Attached Images

This user is offline

Stair Stringer connections

0

steel stair stringers under treads

0

Assembled Stairs - Joining stringers from one set to the landings of another

9

Lineweight Tool Does Not Function For Stair Stringers....

4

Editing Profile of Stair Landing

2