Forums >> Revit Building >> Technical Support >> Stair Stringer Cutting Stair Treads and Risers See Image

Phaeax

active

Joined: Mon, Mar 5, 2012
29 Posts
No Rating

When I create a monolithic stair and I adjust the stringer carriage thickness to >500 I get the result of an angle cut along my entire staircase. How do I change this setting so I can make the Carriage depth as deep as I want . . . It has its practical purposes - just not in the example I attached.

Revit 2013

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

I think nobody ever though that anybody would make monolithic stairs this thick so it was never tested to this extreme. I tested it and it does happen.

You can report this to autodesk.

This user is offline

blue442

active

Joined: Tue, Aug 25, 2009
133 Posts

we had this issue with a stair as well.  we ended up just making it a model in place using a swept profile (it was also on a curve) and used voids to hack off parts on the end.  we couldnt get the monolithic stair to work.

we did not apply railings since it was a residential exterior stair (3'-0 tall).  though in this case i would probably just model them in place too since there was no stringer to attach to.

This user is offline

View Website

Stair Sections, show Treads Beyond in Hidden Lines, no Linework, no Detail Lines

5

Connecting walls to stringers / hiding treads and risers

5

View Title Share Parameter (not working)

0

steel stair stringers under treads

0

stair help with tread AND railing

7