Forums >> Revit Building >> Technical Support >> taking an elevation of a linked model

Warchitect

active

Joined: Wed, Aug 20, 2008
318 Posts

I have a garage linked into my main house model. it sits at 45 degrees to the main house (existing).

so I have four elevations of the main house, but want to make 4 elevations of the garage too, but the elevation tool doesn't even "see" the garage linked model. justs ignores it. so I cant get it to shift into 45 degrees to face the garage. I want to do this so the sheets I create all reference the same sheet set and drawing numbers. any help?

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

I would just place a short temporary wall along the linked model wall and use that for my elevation to point to...then delete the wall.

This user is offline

Warchitect

active

Joined: Wed, Aug 20, 2008
318 Posts

Clever. Thanks, shoulda though of that. 

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

They old guys now missing in the chat room used to call that a "head slap time".

This user is offline

Moving a linked Revit model

3

Elevation visibility in linked models

2

Changing Elevation of Linked Revit Models

4

Not able to place room copied from linked model

4

elevation creation - snap to linked model?

2