Forums >> Revit Building >> Technical Support >> Inserting Bottom Tap Diffussers

slovenc0417

active

Joined: Tue, Oct 6, 2009
1 Posts
No Rating

Fairly new to Revit.

I had trouble inserting diffussers to the bottom of a rectangular duct.  My solution was to create a RCP view of the plan I was working in. This way I was able to "place on face" the diffuser to the bottom of the duct.  Again, since I am new to Revit this seemed like a convoluted way of accomplishing this task.  However, with experience, it may seem second nature.  I was just wondering if there is an eaiser method.

This user is offline

Set baluster on Bottom Rail

4

Cabinets only are inserting dashed

1

Inserting a 2D Component into a new project sheet [ 1 2 ]

20

Inserting text under dimension in string dimension

10

Inserting Links

7