Forums >> Revit Building >> Technical Support >> External Wooden framing family created in Revit 2014 through elevation profile

naseem1982

active

Joined: Thu, Mar 14, 2013
0 Posts
No Rating

Hi there,

Can some one provide solution... how to opload the family correctly into project as its asking for start and end point to place but i dont have these points to the family i hv created. I tried to place it though normal upload and bring profile from project browser to place in the project through side elevation. Each time while providing end point of the model it getting deviated specially wooden louvers.

I am uploading the frame structure here so some one can experiment with any rectangular building block and try to place it on its top to provide second roofing system.

I hope, i am able to convey my problem as its bit complex i guess.........

Thanks in advance....

Mohammad

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

You created this as a Structural Framing family, like a beam it needs a start and end point that you need to draw.  So in a floor plan or roof plan view just select where you want it to start at and end at and it will draw it in.

This user is offline

View Website

naseem1982

active

Joined: Thu, Mar 14, 2013
0 Posts
No Rating

thanks alot for your advice and solution........

This user is offline

Wood Framing Walls Extension; Locating and External framing

2

Revit 2014 - Array within Profile Family

6

Callout on a framing elevation

4

Custom Structrual Framing Tags

1

Metal deck roof profile

6