Forums >> Revit Building >> Technical Support >> Stringer in Stair by Run: Problem with offset

kkohutek

active

Joined: Fri, Aug 10, 2007
24 Posts

Hi everybody,

I searched all the way trough the Forum for an answer for this, but couldn't find.

Here's the thing: I use RAC 2013, and I know that a better way to do the stringers is using the Railling tool, I did that. But it's annoying me the idea that the Stringer Tool inside the Stair is not good enough. 

I used the same profile of a metallic beam in both cases, but in this case the offset of both right and left lateral supports is off, when using Stringer (Closed). I can't manage to change the offset to make the stringer closer to the landing and run.

Only when you switch to Carriage (Open) that the offset is on again, but it doesn't allow me to add a profile to the Support.

So, my question is: what info do I have to change to make the Offset when using Stringer (Closed) on?

Thanks!

Attached Images

This user is offline

View Website

minhtu2004

active

Joined: Thu, Apr 4, 2013
2 Posts
No Rating

-Who are you here? help me! plesea

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Help you with what?

This user is offline

View Website

minhtu2004

active

Joined: Thu, Apr 4, 2013
2 Posts
No Rating

- what info do I have to change to make the Offset when using Stringer (Closed) on?plesae

-Thank! 

http://www.revitcity.com/forum_files/122916_stringerbystair.jpg

Edited on: Tue, May 6, 2014 at 7:46:15 PM

This user is offline

Stair Stringer Offset

5

Stair stringer offset (2015)

2

REVIT 2015 Stair - Straight Run to Curve Run

9

Stair Stringer Question

8

Stair stringer slope doesn't match riser slope?

1