Forums >> Revit Building >> Technical Support >> Breaking a Jogged Section Line - Hiding Central Portion

calev

active

Joined: Wed, Jul 31, 2013
2 Posts
No Rating

In Revit 2012, I have a jogged section line that I want to break (so that the section line does not go through the drawing, but appears on either side of the building in plan). Once I've broken the section callout line, I'm able to drag the two sides outside of the building. However, the central portion of the section line (where it jogs) is still there, and I can't find a way to get rid of it. It's just a floating line in the middle of my plan, and I would like to make it disappear if possible.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

It is not possible ... at least I have never seen or found a way.

This user is offline

calev

active

Joined: Wed, Jul 31, 2013
2 Posts
No Rating

I figured it out finally. You can use the split tool to break the central portion of the jogged central line. Then you can drag the middle points to the outer endpoints. The line becomes nonexistent and pretty much disappears, but you are still left with two tiny dots that mark the ends of the central section line. Much better than seeing the whole line!

This user is offline

Modelling terrain Revit imported from AutoCad

1

Revit beginner & need help with worksets

0

3D PDF and PRC supports the following data

0

local file saving location [ 1 2 ]

18

RevDev Studios - RevEx and RevXL - Spreadsheet plugins for Revit

0