Forums >> Revit Building >> Technical Support >> Move Door in New Phase

STBoyle

active

Joined: Wed, Apr 10, 2013
5 Posts
No Rating

We want to simply flip a door swing in the new construction phase. How do we do this without creating a new door (extra door on door schedule)? This goes for a lot of items actually that we simply want to just save/move to new location. Thank you.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

You will have to have the new family.... NOTE:  You schedule can be - should be phased.

This user is offline

STBoyle

active

Joined: Wed, Apr 10, 2013
5 Posts
No Rating

Yes, figured there must have to be two doors in the same place, but one is demolished I suppose.

We filtered all demolished doors on the schedule out too. However, because we changed the existing door

to be demolished there is a wall fill now in its place. When we place the new door in the new construction phase,

it works ok, but it does not cut out the fill of the wall. We have to hide it in all views (RCP, etc). Is this correct?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

It should work correctly if hosted by the correct wall - the infilled one.

This user is offline

Existing door reused in proposoed phase

2

Door Schedule Multiple Instances of Same File

4

new door in exisiting wall

6

how to tag new vs existing door/windoew of the same kind.

2

Copying doors from one phase to another

0