Forums >> Revit Structure >> Technical Support >> Metal Deck profile question

curtins1

active

Joined: Mon, May 20, 2013
10 Posts
No Rating

I have just made a new metal deck profile and loaded it into my project, I created a new floor type with my new metal deck profile loaded into it and when i come to model the floor i get this line at the bottom (see attachment)

this doesnt show up on all my other floors, Can this be removed ?

Attached Images

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Do you have mroe than one floor in the same place?

This user is offline

View Website

curtins1

active

Joined: Mon, May 20, 2013
10 Posts
No Rating

no i made a new floor type with the new metal deck profile in it and i get a line at the bottom of the floor. on other floors i dont see the line.

Is it something to do with the profile ?

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

"on other floors i dont see the line"  Are you saying these lines have a different metal deck profile?  If so then I would assume it is a problem with the profile you created.

This user is offline

View Website

mpolo297

active

Joined: Wed, Jul 3, 2013
0 Posts
No Rating

Hi,

Not sure if you got your answer already.

Set far clipping setting to Clip without line.

This user is offline

Metal Structural Deck on Floor

2

Revit Metal Deck Question

1

Metal deck roof profile

6

metal deck cut profile

4

Metal Deck

1