Forums >> Revit Building >> Technical Support >> interior elevations tag question

sgray05

active

Joined: Tue, Jan 17, 2012
50 Posts
No Rating

Is there a way to disassocate the name provided in the Project Borwser with what is shown on the interior elevation tag in plan view?

Whatever name I give in the project browser is also showing up on the tag. I am looking to just provide a numbe r(or letter) for the differenent elevations within the same room. 

An additional, somewhat related note. Is there a way to all four elevations be reference to the same detail number on the sheets and only be defined by a letter. 

For instance, single use bathroom. interior elevation is reference to 1/A6.0 with the north elevation being identified as A; east as B; ect..

rather than the north being detail 1, east being detail 2.... 

This user is offline

sgray05

active

Joined: Tue, Jan 17, 2012
50 Posts
No Rating

After some digging I discovered the answer to first part of my question. It is located under Edit Type while having the tag selected. THen you can change the elevation tag type. 

Second part of my question is still an unknown. 

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Your question is not clear.  Obviously, elevation A (or 1) is a different view from B (or 2).  The reference can be number or letter.... change it!

So the result will be A/A6.0, B/A6.0, C/A6.0 .......

This user is offline

interior elevations

5

Adding a Tail to Interior Elevation Tag

2

updating material tag on interior elevations

1

rotating interior elevations

9

View titles lettered for interior elevations, cannot duplicate...

4