Forums >> Revit Building >> Technical Support >> DIMENSIONING WALL ENDS

mongopac

active

Joined: Fri, Feb 16, 2007
41 Posts
No Rating

Apparently, Revit will not all me to dimension the FOS of the ends of walls if I enable wrapping.  It  seems as though it always goes to the outer end of the wall, which is to say, the finished face, however it is I may organize the wrap.

Is there a way to get it to dimension to the face of the core? 

Currently I just draw a little line at the FOS (the line won't even snap to the core, BTW) and dim to that, but of course that isn't very useful if the wall needs to be moved around.

This user is offline

dingohot

active

Joined: Mon, Mar 15, 2010
199 Posts

as i know, wall end wrapping(and insert wrapping) option is a kind of tricks in revit programing,

it doesn't infuluence any other datum except plan views, it means revit can't recognize core face at the end of the wrapped walls.

the way you use is not bad, or you have to make two seperated single walls-core & finish

Edited on: Tue, May 28, 2013 at 8:16:44 PM

-----------------------------------

want more?

You can get more tips at Enjoy Revit

This user is offline

View Website

purgeme2

active

Joined: Tue, Jul 5, 2011
5 Posts
No Rating

It is a very frustrating flaw in revit, i have had the same issue over and over and we find ourselves in 2016 with no answers.

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
19889 Posts

I dimension to the face of walll and note that it is FIN in the dimension.

This user is offline

Reset Grid Behavior

2

DIMENSIONing GRIDS - on plan view

1

Dimensioning to the centerpoint of an arc

7

Wall end at an angle

5

Better/More Flexible Dimensioning

0