Forums >> General Discussion >> Revit Project Management >> Stair Handrail

EBrandon123

active

Joined: Fri, Jul 27, 2012
35 Posts

Could someone please advise me on the best way to complete joins between sketched handrails.

I am trying to create a handrail to a stair of an 8 storey building, one side of the stair needs to have a wall mounted handrail and the well side to have a rail handrail.  The stair consists of 4 flights between each level. As the 2 sides of the stair have different types of handrail I believe I have to sketch the handrail.

Where the flight handrail stops and the landing handrail starts I have a really horrible junction.

Is there a way I can connect these handrails? See attachment.

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Your wall mounted rail should be one sketch.  You will have to pay attention to the "break" point locations in that linework as that will determine the height above the landing.  You may want to sketch this in a section and add a temporary refernce line so you can locate this break at the proper place in plan.

This user is offline

Another handrail issue

2

railing wont update balusters.

0

Handrail Supports on Multistory Stairs

3

Revit Architecture 2013 - Known Issues

0

Can not swap out one stair family for another

6