Forums >> General Discussion >> Revit Project Management >> Different horizontal width mullions corner

pabloazulito

active

Joined: Mon, Jul 30, 2012
4 Posts
No Rating

Hi Folks,

I have two different horizontal width mullions joining at a corner, (as you can see it the image sample) but I can get to make it right. Seems that is difficult when the width varies.

I could model an in place model for this corner, but seems there should be another way around to control how different with mullions join at a corner.

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Seems to me that is the only solution you have given Revit... a mitered corner and all miters are 1/2 the angle.

Model in place is your answer.

This user is offline

pabloazulito

active

Joined: Mon, Jul 30, 2012
4 Posts
No Rating

WWHub,

Thanks again Man!, well that is something autodesk could work on, to make editable mlion conditions, like they did for stairs...

Gracias!

This user is offline

dgcad

active

Joined: Thu, Mar 17, 2005
1231 Posts

Curtain wall mullions (specifically corners) need a serious overhaul. We need an API.

-----------------------------------

FULL 'DOWNLOAD ACCESS' to all 850+ CADclips videos for only $150

This user is offline

View Website

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

We don't miter these.  We extend the CW to the edge of the other CW mullion and then we add a grid at the glass corner and don't have glass in that last sliver panel.  Square mullion by-pas corner, not mitered.  Renders and shows correctly in all views.

This user is offline

cleanup horizontal mullion at corner mullions, again....

7

Horiz mullions wont clean up because of angled corner mullion

0

connecting horizontal mullions around a corner mullion

3

Corner Mullions

2

Different sized Mullions

1