Forums >> General Discussion >> Revit Project Management >> Fascia Board Too Long

thedboys95

active

Joined: Tue, Oct 30, 2012
3 Posts

On my shed I extruded a barn style roof and changed the cut to a Two-Cut Square. When I add a fascia board to the extruded sides of the roof the cut on the fascia board is a plumb cut. How do I change/trim the board so it matches the width and cut of the roof?

This user is offline

mbsteve

active

Joined: Fri, Sep 22, 2006
759 Posts

If you place the fascia board in sequence around the roof, it should create the correct cuts, if you skip around it does not remember what the previous cut was or rather, it uses the previous cuts, to create the next.

This user is offline

thedboys95

active

Joined: Tue, Oct 30, 2012
3 Posts

The barn is 12x16, extruded so that I drew the roof along the 12 side. When I place the fascia board along the 16 side, it is placed perpendicular to the roof for some reason since the roof has a square cut. Along the 12 side the fascia board extends too long and the triangular plumb cut of the board extends past my roof. I can't get my file to post when I attach it so I am trying my best to describe it.

This user is offline

3D Fascia Board Help

3

Can't get fascia heights to match

2

Custom barge board/ fascia end profile

12

fascia on two different sloped roofs

6

Cut Fascia by roof

4