Forums >> Revit Building >> Technical Support >> Foundation plan/level view (R2013)

OlavM

active

Joined: Mon, Nov 12, 2012
5 Posts
No Rating

It should be very easy, but I just can't figure out how to view only foundation plan/view.. Problem is, that I made foundations hosted by walls and now I can only see them in "structural plan - level 1" within the walls, but I would like to see only footings, not with walls.. Shouldn't there be a special "foundation level" or smth in the views panel? Any help is welcome!

Thanks

Attached Images

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

If you have a level called foundation then from your view tab, create a plan of that level.  If you don't, then you can create the level and then make the plan.  Set your view range accordingly.

Also, you can copy the floor plan, change the view range, call it a foundation plan and turn foundations on, walls off.

This user is offline

OlavM

active

Joined: Mon, Nov 12, 2012
5 Posts
No Rating

How do I just copy the floor plan? Like I said, I have only structural plan level 1 where the footing with walls can be seen. I would like to create foundation plan without walls. The question is how?

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Fundamentals....

View tab -  / plan views / floor plans / uncheck the do not duplicate box and pick your level.  Set your view range and VG settings.

This user is offline

Foundation Plan Help

1

Level 1 room boundries showing up in foundation level

0

Changing Linetypes in Foundation Plan

7

Foundation plan view depths

9

Plan view levels

4