Forums >> Revit Building >> Technical Support >> walls disassociated with mass - can't update walls

KseniaEic

active

Joined: Wed, Mar 21, 2012
15 Posts
No Rating

So I have a bit of a problem.

I have a project with an angled wall so I built a mass and made the walls by the command model by face. Worked fine and I could update the mass and then update the walls... however, at some point a couple of weeks ago I deleted my mass without realizing and when i went to fix something I couldn't. I found an old file and copied the mass in but the walls aren't associated to that mass... How do I fix this and make them reassociate with the new mass? Or is this even possible?

Also I'm getting pretty sick and tired of having to re-do the windows and doors every time i update the walls in a way revit doesn't like. This happened before I deleted the mass by mistake and now i'm dreading redoing the walls on this new mass as i'll have to redo all the windows, all the callouts, etc.

Thanks

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

You should always put the mass in a different workset that is normally off.

I suggest you copy the mass and associated wall from the old file.

This user is offline

Tops of the walls applied to mass looks horrible

2

Slopping Walls

14

Mass and walls are squiggled

2

See-through walls? I can't make the walls solid.

1

How to attach top/base - walls to mass roof

6