Forums >> Revit Systems >> Technical Support >> Routing Preferences - Pipe MEP

malagon03

active

Joined: Thu, Sep 20, 2012
1 Posts
No Rating

say, I have a pipe run that bends at 88 degrees and then bends again at 45 degrees (same Diameter). if I check the types selected by my routing preferences, both of my bends are shown by the diameter, and THE SAME Family Type is listed for both bends when the 45 type is different to the 88 type. how can I set my routing preferences on pipes for Diameter and ANGLE variations??

This user is offline

Routing preferences junction problem

2

How to load Routing prefrennces at once?

1

Video Tutorial - REVIT 2013 MEP Hot and Cold Water Pipe Routing

0

Pipe size

1

REVIT MEP PIPE WORK

1