Forums >> Revit Structure >> Technical Support >> Walkthrough Key frame Levels Change Revit 2012

TeamNga

active

Joined: Tue, Feb 24, 2009
46 Posts

Is there a way to change my key frame levels after the walkthrough is created?

While I am creating my walhthrough I can select the level I want my camera to be placed. After viewing it I noticed that I would get a better result if I could change my camera level for my frames 8 through 12 for example.

How can this be done?

Thank you.

This user is offline

fastjohnnyz

active

Joined: Thu, Jan 29, 2009
51 Posts

 I also have that same question. But I have done a "work around" for it. Not ideal, but it gets the job done. Insert a building section where your 8 - 12 frames are. Then go and click open your walk thru in the browser. Highlight the cropped area and click edit walk thru. Switch to your building section and you will see the elevation path (in blue see attached jpeg) of your walk thru. At the top click modify/cameras. Then go to your options bar and under controls switch from active camera to path. Then you can select the round blue circles in the path. Move them up or down.

 Hope that helps you out somewhat.

Attached Images

This user is offline

fastjohnnyz

active

Joined: Thu, Jan 29, 2009
51 Posts

I also found this (see attached)

Attached Images

This user is offline

Walkthrough - 3D orbit/change levels

1

Revit Walkthrough; between key frames

1

How change levels in a walkthrough? (walking from 1st to 2nd story)

5

walkthrough rendering frame counter?

6

Adjusting height of key frames in walkthroughs

3