Forums >> Revit Building >> Technical Support >> Site Elevation to Floor Level Problem

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Maybe I am missing something really simple but I just can NOT figure this out!  I have a floor level at 1688', I start drawing my toposurface which is at 1683' (for the first few points). when I go into an elevation I would expect to see the toposurface 5 feet below the floor level but instead it is 95' above the floor level.  Now in our template we have our default floor level set up at 100' so is there something in a setup that is forcing the toposurface to offset 100' above the floor level?

Attached Images

This user is offline

View Website

dgcad

active

Joined: Thu, Mar 17, 2005
1231 Posts

This is a tricky one to field in text over a discussion group.

It has to do with the 'elevation base' type property of the levels themselves [project or shared] and whether the project was relocated or not.

-----------------------------------

FULL 'DOWNLOAD ACCESS' to all 850+ CADclips videos for only $150

This user is offline

View Website

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

Thanks!  Our level type properties was set to survey point instead of Project Base point!

This user is offline

View Website

Topo surface points change from relative to absolute elevations

11

Odd Level/family placement issue

1

create floor or other solid mass from Topo

10

Changing Level Heights and having corresponding objects move

3

Issues with Linked View

0