Forums >> Revit Building >> Technical Support >> How to infill a topo hole from plit surface

JRPcad

active

Joined: Thu, Jul 1, 2010
136 Posts
No Rating

I have revisited a model I worked on a while back where a client has decided they wanted to remove a ramp. I originally decided to split the surface to cut away the topo so that it didn't make te ramp look dodgy (where as if i had done it now I would have used a pad instead of splitting) I deleted the split element which obviously left a hole in my topo. Is there a way to infill this hole, e.g. put some topo back there so there is no hole. I tried inserting points into it thinking that would be the obvious way but Revit said no.

Anyone know how I can infill this this topo hole without having to remake the topo from scratch?

-----------------------------------

For Architectural Services visit www.jrpcad.co.uk

This user is offline

View Website

JRPcad

active

Joined: Thu, Jul 1, 2010
136 Posts
No Rating

Lol I just found the solution as soon as I posted,

All I had to do was delete the points that created the boundary for the hole, I ddn't think this would work as I couldn't selected the edges of the hole, But all good now

-----------------------------------

For Architectural Services visit www.jrpcad.co.uk

This user is offline

View Website

topographical sidewalk

2

Modeling Topo After Building

2

infill wall alignment to host wall

2

Topo elevation reports different value than actual location on z-axis in model

4

Setting wall to demolition, infills - how to stop?

1