Forums >> Revit Building >> Technical Support >> SAT file not showing in elevation other views OK

erickson1026

active

Joined: Thu, Apr 29, 2010
34 Posts
No Rating

I just inserted an SAT file into Revit 2012.  The coffee maker model works OK in all views (plan and elevation shown) except the elevation.  Checked all the VG categories.  No luck

Any tips are appreciated.

Dave E

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
2709 Posts

Check to make sure its not hidden and that your detail level is set to fine

This user is offline

View Website

erickson1026

active

Joined: Thu, Apr 29, 2010
34 Posts
No Rating

Thanks for that.  View set to fine and checked hidden elements.  No luck though. I have attached a screen shot.  If you look closely you'll see the coffee maker elevation in half tone.  Just doesn't show up in view.

David

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
2709 Posts

Did you make this coffee maker?  I would check the family and make sure all of the settings are correct for viewing there also.  Otherwise try uploading the family and I'll see if I get the same results.

This user is offline

View Website

erickson1026

active

Joined: Thu, Apr 29, 2010
34 Posts
No Rating

I downloaded the SAT file from a sharing site, then created a family from it and inserted it as a component into Revit 2012.

I have attached the SAT and the RFA if you would like to take a look. 

If it's a hassle don't worry about it.

Thanks.

This user is offline

create floor or other solid mass from Topo

10

2010 Conceptual Massing and .sat files

10

Light fixture doesn't produce light

1

Revit beginner & need help with worksets

1

Revit Architecture 2013 - Known Issues

0