Forums >> Community >> Newbies >> Ceiling edit boundary problems

Majadero

active

Joined: Wed, Mar 2, 2011
5 Posts
No Rating

Hi all,

I have a problem with my lay-in ceiling, everytime I try to edit its boundary the ceiling banishes and the boundary appears on the  second level, this is a problem since areas of my first floor do not align with my second floor (different foot prints). thus the boundary floats in spaces with no walls. Is there a setting am I missing?

I am curreently using Revit 2012 

thanks

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

Check your ceiling host level. 

Even if the ceiling is hosted on a lower level, you should still be able to edit it from any plan.

This user is offline

Majadero

active

Joined: Wed, Mar 2, 2011
5 Posts
No Rating

Thanks for your replying to my post

The host level is the first level flooor and the ceiling is set aT 9' above it.

We also checked on the vicibility graphics, thinking that VG had to do with it, but it didn't solve anything.

I will check on the host level, but I am sure it is set correctly, it is just puzzling cus we have a few projects going and this is the only one with this problem. I should add that the same thing happens while trying to eddit soffits

This user is offline

WWHub

site moderator|||

Joined: Tue, May 16, 2006
13079 Posts

You say you checked VG.  Are all lines on in VG for the plan in question?

This user is offline

Majadero

active

Joined: Wed, Mar 2, 2011
5 Posts
No Rating

You got it. Problem solve. The lines were off on my VG, once I turned them on the boundary was editable on the frist level

thank you so very much !!

This user is offline

Beam System is not resetting after I edit the boundary.

6

Background fade during Boundary Edit

2

Interior Elevations - darker irregular boundary lines

0

Barrel Vault ceiling problems

1

Edit Split Face on Ceiling

6