Forums >> Revit Building >> Technical Support >> Elevation Tag Issue

esahnow

active

Joined: Tue, Oct 7, 2008
27 Posts
No Rating

Revit 2012

I modified the elevation tag to look like our ACAD standard. The circle diamater went from 1/2" to 3/8" and now my sheet callout number is not aligned and I can't figure out why. I've attached an image of it for clarification.

Any suggestions?

-----------------------------------

Eric Sahnow

Project Lead/Designer

This user is offline

teafoe5

site moderator|||

Joined: Fri, Nov 12, 2010
1749 Posts

It would help if you attached your actual family.  Are they aligned in your family and not when you bring it into a project?

This user is offline

View Website

esahnow

active

Joined: Tue, Oct 7, 2008
27 Posts
No Rating

Here is my family. Everything looks good to me, I tried to adjust as little as possible.

Thanks for your help. This one has me frustrated. 

-----------------------------------

Eric Sahnow

Project Lead/Designer

This user is offline

esahnow

active

Joined: Tue, Oct 7, 2008
27 Posts
No Rating

Anyone have any luck with this issue? I'm tempted to just resort back to the stock 1/2" circle that works but it looks WAY too big on the sheet and does not match our office standards.

-----------------------------------

Eric Sahnow

Project Lead/Designer

This user is offline

Polar

active

Joined: Sat, Dec 6, 2008
57 Posts
No Rating

The advice I've heard is:

1. if you want different tag sizes create and load them at the beginning of a project

2. make a template with the tags already loaded

Not much help mid-project though....

-----------------------------------

think it - build it

This user is offline

Sim location issue on Elevation tag

1

Changing the size of the interior elevation tag

1

Beam Tag with Top of Steel Elevation ?

4

Interior Elevation Tag missing from drop down

3

Revit 2018 Elevation Tag Location

2